Osha Fall Protection Roof Edge

Subsequently there are a variety of safety requirements for protection from falling in the construction roofing industry.

Osha fall protection roof edge.

Except as otherwise provided in paragraph b of this section each employee engaged in roofing activities on low slope roofs with unprotected sides and edges 6 feet 1 8 m or more above lower levels shall be protected from falling by guardrail systems safety net systems personal fall arrest systems or a combination of warning line system and guardrail system warning line system and safety net system or warning line system and personal fall arrest system or warning line system and. Edge fall protection s roof hatch railing tackles roof hatch safety railing concerns by providing an osha compliant hatch guardrail system around the hatch. Falls are the leading cause of injury and death among roofers. In addition the code continues to specifically address fall protection near mechanical equipment which is where the edge accufit safety railing was being placed to protect requirements stating guards shall be provided where various components that require service are located within 10 feet of a roof edge or open side of a walking surface and such edge or open side is located more than 30 inches 762mm above the floor roof or grade below.

Osha s fall protection standards at 29 cfr 1926 subpart m to protect workers exposed to falls six feet or more above a lower level. When where you need fall protection for unprotected sides and edges on low slope roofs osha 1910 28 b 1 i requires employees to be protected from falling when the walking working surface is 4 feet or more above the lower level by one of the following. Employers are to ensure that each employee is protected from falling by using fall protection systems such as guardrails safety net system fall restraint or fall arrest systems. Between 6 feet and 15 feet from the roof edge.

Section 1926 501 b 10 sets out the fall protection requirement for roofing work on low slope roofs. Each employee on a walking working surface horizontal and vertical surface with an unprotected side or edge which is 6 feet 1 8 m or more above a lower level shall be protected from falling by the use of guardrail systems safety net systems or personal fall arrest systems. Supervise workers to ensure fall protection equipment is used and maintained correctly. Osha defines what fall protection is required based on how close employees are to the edge of the roof.

Common violations under this standard include failure to provide protection from falling near unprotected sides or edges and on both low slope and steep roofs. Under that section an employer may use a combination of warning lines 6 feet and in some cases 10 feet back from the edge in combination with monitors in place of personal fall protection equipment or guardrails. Unprotected sides and edges. Our completely freestanding roof hatch safety railing goes over the top of the roof hatch and uses compression to fit up against the curb of the hatch.

Implement safe work practices to reduce the possibility of falls.