Osha Fall Protection Roof Maintenance

Except as otherwise provided in paragraph b of this section each employee engaged in roofing activities on low slope roofs with unprotected sides and edges 6 feet 1 8 m or more above lower levels shall be protected from falling by guardrail systems safety net systems personal fall arrest systems or a combination of warning line system and guardrail system warning line system and safety net system or warning line system and personal fall arrest system or warning line system and.

Osha fall protection roof maintenance.

This means that the building owner needs to work with their maintenance staff to develop a safe work plan for any work on the roof. For general industry working at a 4 foot height or a low sloped roof osha requires. However where the potential for falls exists protection must be. Implement safe work practices to reduce the possibility of falls.

Osha 1910 walking working surfaces standard requirements. This makes it pretty obvious that anybody close to the roof s edge would need pfas rails or some means of fall protection. You send workers up on the flat roof to fix an hvac unit. Osha s fall protection standards at 29 cfr 1926 subpart m to protect workers exposed to falls six feet or more above a lower level.

Conversely they can leave it up to individual contractors to provide safe access to the roof during maintenance activities. Osha estimates the rule will prevent 29 fatalities and 5 842 injuries annually. Conventional fall protection guardrail fall restraint or fall arrest system is required. Osha considers it a working area.

Supervise workers to ensure fall protection equipment is used and maintained correctly. General industry fall protection when performing hvac maintenance on roofs 1 osha s general industry standard 1910 132 a would apply. You send workers in to a tank to clean and paint it. With regard to fall protection requirements applicable to the construction work itself 1926 501 b 10 low slope roofs requires conventional fall protection a combination of a monitoring system and warning line or on roofs of 50 feet or less in width a monitoring system alone i e without a warning line be used.

Is the work considered maintenance covered under osha s general industry fall protection rules or repair subject to osha s construction rules. In regards specifically to roof fall protection the 1910 standard specifies for low slope roofs that when work is performed less than 6 feet 1 6 m from the roof edge the employer must ensure each employee is protected from falling by a guardrail system safety net system travel restraint system or personal fall arrest system. 6 feet from the edge.