Osha Flat Roof Fall Protection Requirements

Between 6 feet and 15 feet from the roof edge.

Osha flat roof fall protection requirements.

Employers are to ensure that each employee is protected from falling by using fall. Subpart m 1926 501 b 10 of the osha construction standards specifies that under certain conditions roofing work can be conducted with a warning line in place 6 feet from the edge and a safety monitoring system. Lay headers sheets of roofing or other materials no closer than 5 feet inside the edges of the roof and parallel to the roofline. Each employee on a steep roof with unprotected sides and edges 6 feet 1 8 m or more above lower levels shall be protected from falling by guardrail systems with toeboards safety net systems or personal fall arrest systems.

Fall protection systems and other equipment they will be using on the job. Employers are to ensure. Understand the requirements of osha s fall protection standards at 29 cfr 1926 subpart m to protect workers exposed to falls six feet or more above a lower level. Osha defines what fall protection is required based on how close employees are to the edge of the roof.

Implement safe work practices to reduce the possibility of falls. Supervise workers to ensure fall. When the fall protection measures listed above are not used mark the edges of the flat roof with headers and warning lines to notify workers of potential fall hazard areas using the following guidelines. How it is addressed depends on the type of work being done.