Osha Roof Access Ladder Cage Requirements

The top of the cage shall be a minimum of 42 inches 1 1 m above the top of the platform or the point of access at the top of the ladder with provision for access to the platform or other point of access.

Osha roof access ladder cage requirements.

Several of the important changes are listed below. 1910 23 d 4 i the roof if the parapet is cut to permit passage through the parapet. Vertical bars must be on the inside of the horizontal bands and must be fastened to them. Osha s new ruling was designed in part to create more uniformity between the general industry and construction standards.

In the past osha has required cages for fixed ladders taller than 20 feet but as of january 2017 fall protection is required on fixed ladders taller than or that extend beyond 24 feet. 1926 1053 a 21 wells for fixed ladders shall conform to all of the following. For starters prior to the new ruling the only real guidance on fixed ladders came from the construction standards osha more 1926 1053 a 18 required the use of cages wells ladder safety devices or self retracting lifelines for fixed ladders of 24 feet or more. For parapet ladders the access level is.

The minimum amount of flare required at the bottom of the cage 4 inches. The standard states that safety cages or wells shall be provided on ladders of more than 20 feet to a maximum unbroken length of 30 feet. Literal compliance with osha s standard therefore would require a safety cage or well but see the answer to question 4 below for the current status of this standard. This is the same height that osha requires for guardrails.

For fixed ladders that extend more than 24 feet 7 3 m above a lower level 29 cfr 1910 28 b 9 i requires that each fixed ladder installed before november 19 2018 is equipped with a personal fall arrest system ladder safety system cage or well and each fixed ladder installed after this date is equipped with a personal fall arrest system or a ladder safety system. To protect the worker exiting a ladder osha requires a 42 inch high grab bar extension above the access level or landing platform at the top of the ladder. 1926 1053 a 21 i. Per osha 1910 23 d 4 the side rails of through or sidestep ladders must extend 42 inches above the top of the access level or landing platform served by the ladder.

Horizontal bands must be fastened to the side rails of rail ladders or directly to the structure building or equipment. The side rails of through or sidestep ladders extend at least 42 inches 1 1 m above the top of the access level or landing platform served by the ladder.