Owlet Sock Sensor Not Charging

The owlet smart sock is a consumer product that provides parents insights into their baby s wellness as well as peace of mind each time the parent puts their child down for a nap or to sleep at night.

Owlet sock sensor not charging.

Charge at least every day. For a simple reset turn the electronics back on. A base station receives the signal from the smart sensor device that gets attached to the socks. There are four possible reasons why your sensor is not charging.

Charge the sock battery by plugging the sensor into the base station and the base station into an electrical socket. Track your baby s heart rate oxygen levels and sleep all while streaming live video. The sensor is the white electronic inside the fabric sock and shown in the picture below. Below we will review all four reasons.

Smart sock fit placement. How to charge the smart sock. The base station is not accepting a. Battery lasts approximately 18 hours this can vary depending on the physiology of your child.

And the redesigned base station offers wireless drop and go charging a huge time saver. Sock plugged in sock in use not charging if needed re charge the smart sock. On the front there is a logo and on the side are two micro usb port to charge the base station and to charge the sock sensor. It also monitors babies through gentle motion so you get live readings more often.

These four reasons are. With these changes the sock now fits babies both bigger and smaller from 5 lbs. Takes approximately 3 4 hours until full charge. The base station receives information from the owlet s pulse readings.

Get an 8 hour charge in under 20 minutes and a full 16 hours in 90 minutes. The sensor charging cable is worn broken. You may continue to have blue notifications and will not be able to get reads if your smart sock battery is dead or dying. If the lights will not turn off use a refrigerator or similar magnet dragging it across the bottom of the electronics dome.

Reset turn off the smart sock. The sensor charging cable needs to be replaced. All it s says in the menu option is that it is charging. Once the lights have turned off wait 60 seconds and then plug the smart sock electronics back into the base.

Examples of poor sock fit. Open the owlet app and check the smart sock battery gauge under settings in the lower left corner. Pairing your new sock. It is a little frustrating to not have a sense how much the sock is charged besides it being fully done and no longer blinking green.

The owlet smart sock is not a fda approved medical device and is designed and intended for families with healthy infants. If your goal is to turn the electronics off stop here.